Page 1 of 1

BTAS reg spacer size

Posted: Sat Nov 25, 2017 9:50 pm
by jinxs
I would be grateful if any one could please tell me the length of a BTAS reg standoff/spacer is for a s410 many thanks.
Cheers,
Steve

Re: BTAS reg spacer size

Posted: Sun Nov 26, 2017 10:01 pm
by Roger5
This will probably not help you much, I stripped my BTAS S510 awhile ago but didn't measure the standoff, if I use it over the next week I will take the cylinder off and measure it, my Altaros reg'd rifles have standoffs of 24.9mm, the BTAS one might be a bit shorter, as he done rather a lot of drilling around the firing valve. Rog

Re: BTAS reg spacer size

Posted: Mon Nov 27, 2017 8:49 am
by jinxs
Hi Roger5, many thanks for your reply.
Cheers,
Steve

Re: BTAS reg spacer size

Posted: Mon Nov 27, 2017 10:35 am
by Roger5
Hi Steve, did you find what you required from the other forum. Rog

Re: BTAS reg spacer size

Posted: Tue Nov 28, 2017 7:42 pm
by jinxs
Hi Roger, sorry to say not found out yet, need to find out the length of the standoff/spacer.
Cheers,
Steve

Re: BTAS reg spacer size

Posted: Tue Nov 28, 2017 10:17 pm
by Roger5
30 shots out of it yesterday, and as soon as it dumps its air I will pull cylinder off and measure it. Rog

Re: BTAS reg spacer size

Posted: Fri Dec 01, 2017 10:12 am
by Roger5
Just measured it at 28.3 mm, hope that helps. Rog

Re: BTAS reg spacer size

Posted: Fri Dec 01, 2017 7:28 pm
by jinxs
Roger, your a diamond , many thanks .
Cheers,
Steve