Page 1 of 1

Wanted special tool

Posted: Mon Jun 05, 2017 10:41 pm
by Brendon1997
Hello guys, I've a air arms s200mk3 and have bought a pressure guage for it but need the little tool that looks like a big nut that goes over the gold fill valve and locks on in the 2 holes with 2 steel bars, which then allows me unscrew the valve from the cylinder, I was wondering if any of yous had one of those little tools I could buy? As I've tried all over the internet and they are all out of stock, many thanks brendon

Re: Wanted special tool

Posted: Mon Jun 05, 2017 10:58 pm
by eboswan
Leave a message for Julian in the spares section I'm sure he can get you one .

Re: Wanted special tool

Posted: Mon Jun 05, 2017 11:04 pm
by Brendon1997
Hi mate, thankyou I've just posted mate

Re: Wanted special tool

Posted: Wed Jun 07, 2017 10:32 pm
by davyt63
A decent set of circlip plyers will do the job,or if you have access to a jigsaw and welder you Can make one like I did.on the same design of a angle grinder spanner.

Re: Wanted special tool

Posted: Thu Jun 08, 2017 6:26 pm
by Raj
http://www.altaros.cz/en/cz/10-regulato ... /|demoTab3

Scroll down when the link opens and look at the 3rd tab - Instructions ;)