TX becomes not so accurate

TX becomes not so accurate

Postby FPoole » Fri Jan 06, 2017 12:17 am

My MarkII began acting up. It was shooting fairly tight groups, but there was a high one and a low one about .75" apart. Did the barrel clean, screw snug up routine and tried to twist the barrel and muzzle piece. I've had both these parts come loose on these older guns. Everything was fine so I pulled the stock for the stock bracket screw check. That's when I saw aluminum filings at the forward trigger guard screw and the lug it goes into. The stock is cracked between the front guard screw hole and the trigger housing opening, but it had seemed fine for a long time. The lug was touching the guard before the stock was snugged up into the stock. It had rubbed through the paint and was wearing off the aluminum. I drilled a .5" hole into the guard using the forward screw hole as a guide. This lets the lug slip up inside the guard and stops the touching. All is now well. Amazing how such a tiny amount of play can cause some big poi shifts. I've seen this in some aftermarket stocks, but never in a factory stock. It must have been the crack to blame.
Posts: 287
Joined: Mon Feb 16, 2015 2:37 am
Location: Plant City, FL (1 hour west of Disney World)

Re: TX becomes not so accurate

Postby Blackbaronfish » Fri Jan 06, 2017 7:08 am

It doesn't take much to change the harmonics does it :o . With that change of poi you would be looking for something wobbly :mrgreen: .
Well done and sorted 8-)

Did I mention that I'm the only one to have attended every annual meet since we started
User avatar
Super Admin
Posts: 2948
Joined: Sun Feb 15, 2015 6:20 pm
Location: Nuneaton

Re: TX becomes not so accurate

Postby nitro » Tue Jan 17, 2017 1:29 pm

well spotted ... glad you found the problem and can now get it back to its usual accuracy again :D
Posts: 41
Joined: Fri Feb 20, 2015 7:35 pm

Return to Spring guns and tuning

Who is online

Users browsing this forum: Bing [Bot] and 1 guest