S410 Reassembly
Posted: Sun Oct 15, 2017 10:09 pm
Hello all, I am a newbie to Air Arms and whilst there are plenty of videos on YouTube showing how to strip down the S400 series, there don't seem to be any showing reassembly (perhaps I'm just not looking hard enough)
I just stripped down a 2nd hand S410 as it was a little low on power. I just went as far as cleaning off the hammer rail (easy enough as the previous owner had removed the AT blanks) the rail was mucky as anything. However on reassembly I've struggled to:
- get the bolt to reliably engage the hammer and cock it
- get the magazine indexing mech to engage with the bolt!
- the action / trigger unit has ended up very very slightly skew to the air cylinder, so the fit to the stock isn't quite right.
Feels like it should be straightforward, but I can't seem to find anything online, your help would be greatly appreciated!
Regards
R
I just stripped down a 2nd hand S410 as it was a little low on power. I just went as far as cleaning off the hammer rail (easy enough as the previous owner had removed the AT blanks) the rail was mucky as anything. However on reassembly I've struggled to:
- get the bolt to reliably engage the hammer and cock it
- get the magazine indexing mech to engage with the bolt!
- the action / trigger unit has ended up very very slightly skew to the air cylinder, so the fit to the stock isn't quite right.
Feels like it should be straightforward, but I can't seem to find anything online, your help would be greatly appreciated!
Regards
R