S410

no avatar
Jimtqf
Posts: 3
Joined: Wed Feb 15, 2017 3:09 pm

S410

Wed Feb 15, 2017 3:13 pm

Hi all, my guns bolt has gone all floppy and come loose, I have taken it off and tried to reset it, but now the grub screw won't go all the way home, hence it not being tight, any ideas please

no avatar
granville
Posts: 602
Joined: Sun Feb 15, 2015 7:33 pm

Re: S410

Wed Feb 15, 2017 5:06 pm

which screw , the one on the bolt ?
or the one that you get at from below ?
there is one on the bolt guide as well , the oring
holds it tight when engaged .
welcome Jim .
Julian on here is the man for spares .

no avatar
Jimtqf
Posts: 3
Joined: Wed Feb 15, 2017 3:09 pm

Re: S410

Wed Feb 15, 2017 9:30 pm

Hi, the only screw I can see is the one straight behind, was told online to use a loctight product, but does not seem right

no avatar
TenMetrePeter
Posts: 1043
Joined: Wed Jun 29, 2016 5:40 pm
Location: Luton Beds UK

Re: S410

Wed Feb 15, 2017 10:28 pm

If you mean the cap head screw that holds the bolt handle onto the bolt and screws into the end of the bolt, I just repaired one belonging to a friend by loctiting it back on last week.
The screw hole in the bolt handle was so tight it actually had a partial thread cut in it which is wrong. It stopped the screw from tightening properly. Could have been old loctite which was all over the screw but not on the bolt. Factory error in my opinion.
Cock the rifle.
Take the handle off and in your hand turn the screw til the false "thread" strips. Before screwing the handle back onto the bolt, clean nside the handle and the end of the bolt with acetone. Then put a drop of loctite inside the handle bore where the bolt sits. Fit the handle without pushing the bolt forward. Wipe the rest of the bolt and make sure the bolt then has lots of moly grease on in case any Loctite leaks out into the bolt housing and locks it up!. Adjust the position so there is about 8mm gap between the handle knob and the stock when locked down. Check for correct operation before letting the loctite set.
Item no 26 below...
Screen Shot 2017-02-16 at 00.11.23.jpg
Screen Shot 2017-02-16 at 00.11.23.jpg (18.72 KiB) Viewed 3187 times


If its not that screw, ignore all of the above!

no avatar
Jimtqf
Posts: 3
Joined: Wed Feb 15, 2017 3:09 pm

Re: S410

Thu Feb 16, 2017 9:46 pm

Ok all, many thanks, will invest in some loctite, and give it a bash, will let you know how I get on

no avatar
TenMetrePeter
Posts: 1043
Joined: Wed Jun 29, 2016 5:40 pm
Location: Luton Beds UK

Re: S410

Thu Feb 16, 2017 10:29 pm

Look at this on eBay http://www.ebay.co.uk/itm/380851837556

grade 638 designed for cylindrical applications like this

User avatar
Raj
Posts: 2005
Joined: Sun Feb 15, 2015 9:36 pm
Location: Rugby

Re: S410

Fri Feb 17, 2017 7:53 am

Or go to your local garage and scrounge a drop because that is all you need .... literally.
“It's the Indian, not the arrow"

Post Reply

Who is online

Users browsing this forum: No registered users and 21 guests