Page 1 of 1

shrouding and s410k barrel

Posted: Sun Oct 09, 2016 6:26 pm
by hardtail
hi guys thinking of shrouding the s410k just wondering if its just a case of a s510 sleeve and 8 clamp or is it no a diy job

Re: shrouding and s410k barrel

Posted: Sun Oct 09, 2016 6:33 pm
by Blackbaronfish
The breech block on the 410 hasnt got enough height to allow a for a shroud.The 510 series have a larger gap to allow for one.

BBF

Re: shrouding and s410k barrel

Posted: Sun Oct 09, 2016 7:24 pm
by hardtail
cheers for clearing that up m8

Re: shrouding and s410k barrel

Posted: Tue Oct 11, 2016 11:57 pm
by Mark112
Hi,

Some people have 'tarted' the look of their S4*0's by sleeving it in carbon fibre tube though. 12mm inside diameter. You will need to fit a new barrel band capable of taking the 14mm O/D of the tube. Rowan do them. Depends whether it's for form or function.

Mark

Edit. Has anyone here done this and if so did it stiffen the barrel up?

Re: shrouding and s410k barrel

Posted: Thu Oct 13, 2016 8:40 pm
by billywhizz
Mark, I did this too my 400 a year ago ,since sold it. it didn't stiffen it up ,but it certainly made it look a lot better than the spindly barrel did, I did talk with matt the silencer maker about a shroud ,but never got round too sorting it,so settled for the carbon fibre tube.

Re: shrouding and s410k barrel

Posted: Thu Oct 13, 2016 8:58 pm
by TenMetrePeter
Anyone found a carbon tube to fit AA 14mm barrel?. I have seen them on the ebay but "14mm ID" could be just too tight and 30 quid down the pan.

Re: shrouding and s410k barrel

Posted: Thu Oct 13, 2016 9:33 pm
by Brooksy
Try a company called Easy Composites in Stoke.

Re: shrouding and s410k barrel

Posted: Sat Oct 15, 2016 2:30 pm
by Mark112
TenMetrePeter wrote:Anyone found a carbon tube to fit AA 14mm barrel?. I have seen them on the ebay but "14mm ID" could be just too tight and 30 quid down the pan.

What about £11-50 delivered then?

http://www.ebay.co.uk/itm/1-x-OD-16mm-x ... SwT5tWQEn-

Mark

Re: shrouding and s410k barrel

Posted: Sat Oct 15, 2016 5:06 pm
by TenMetrePeter
Its good if the ID is 0.01mm bigger than the 14mm barrel and a total waste if its 0.01mm smaller. Nobody provides tolerances so I wondered if anyone actually fitted one and from where.

Re: shrouding and s410k barrel

Posted: Sat Oct 15, 2016 7:17 pm
by Blackbaronfish
What about this
http://www.ebay.co.uk/itm/300894501448? ... S1.R9.TR11
You could go in with someone else to reduce cost ;)

BBF