AA S410F loose barrel?
Posted: Fri Aug 21, 2015 2:54 pm
Just checking in to see any other guys have experienced this. I have owned the 410 for a few months now but had little opportunity to set it up. Today with my AA410 fitted with a Hawke 6-24x50 pa scope I decided to set it up at long last. I could not get move the impact point to the right as far as needed before I run out of adjustment. I thought either my scope, not likely, or my mounts were faulty. As I was packing it away I grasped the barrel and cylinder and the barrel moved. When I checked the figure 8 securing bracket screws were not tight allowing the barrel to move in relation to the centre line of the rifle. I have tightened the allen screws up and all seems fine except I will have to, at a later date, realign the barrel and make sure it doesnt happen again. Is this something others have experienced?
Thanks
Thanks