Page 1 of 1

Fx bobcat/verminator hybrid stock

PostPosted: Sun May 03, 2015 5:28 pm
by Volac
Hi Geordie mate.You been recommended to me by airgunbbs member

Fx bobcat/verminator 2 custom stock wanted.
Hi, I've recently purchased a gun off a friend, he initially had a fx bobcat then bought a verminator 2, I think he decided to experiment and merger the two guns having the bobcat block and having both air cylinders in one gun, the back buddy bottle is covered well, but his biggest problem has been with cutting the stock from verm to fit the customised gun. but there is a stock on there and fits and the holes have been drilled out a bit further to adjust for room for the filling adaptor which feeds both air cylinders attached to this gun, you fancy the job customising a walnut stock on this for me? Or give me a price? Oh I love in the middle of sheep country in on a tight budget.
Regards Taff

Re: Fx bobcat/verminator hybrid stock

PostPosted: Sun May 03, 2015 7:04 pm
by wastrel
I doubt Geordie cares too much where you choose to get, erm, coitus! though with what :shock: I think you`ve tipped us all off there mate (shame on you!)
your location might help though :lol:

Re: Fx bobcat/verminator hybrid stock

PostPosted: Sun May 03, 2015 7:31 pm
by Volac
On mid west Aberystwyth mate

Re: Fx bobcat/verminator hybrid stock

PostPosted: Sun May 03, 2015 8:07 pm
by Raj
Volac wrote: Oh I love in the middle of sheep country .....
Regards Taff

Freudian slip or what ?? !!!! :lol: :lol: :lol:

Welcome on board, Taff. :) :)

Re: Fx bobcat/verminator hybrid stock

PostPosted: Sun May 03, 2015 8:22 pm
by Geordie
Volac wrote:Hi Geordie mate.You been recommended to me by airgunbbs member

Fx bobcat/verminator 2 custom stock wanted.
Hi, I've recently purchased a gun off a friend, he initially had a fx bobcat then bought a verminator 2, I think he decided to experiment and merger the two guns having the bobcat block and having both air cylinders in one gun, the back buddy bottle is covered well, but his biggest problem has been with cutting the stock from verm to fit the customised gun. but there is a stock on there and fits and the holes have been drilled out a bit further to adjust for room for the filling adaptor which feeds both air cylinders attached to this gun, you fancy the job customising a walnut stock on this for me? Or give me a price? Oh I love in the middle of sheep country in on a tight budget.
Regards Taff



Sorry mate, it's not a job I'd relish like, so it's a no from me.

Re: Fx bobcat/verminator hybrid stock

PostPosted: Sun May 03, 2015 10:58 pm
by Volac
No worries I've just met a lad who's up for the challenge . No worries

Re: Fx bobcat/verminator hybrid stock

PostPosted: Sun May 03, 2015 11:00 pm
by Volac
I love living in the middle of sheep country down here in mid rural Wales ha